SAMPLE DRAWING AND INSTRUCTIONS:

In order for your preliminary estimate to be accurate, try to give as much information as possible on your rough drawing.  It does not have to be to scale.  use a blank sheet of typing paper if possible.  Grid paper makes it difficult to read. 

1.  The small X's on the edges denote areas that need to be polished.  This is only necessary if you want to know how much it would cost to upgrade from the standard eased edge.  Please note the upgraded edge you would like on the drawing.  Indicate splash locations and splash height desired also.

2.  Areas not marked with an X will be rough polished.  Examples include an edge that butts up to a refrigerator that is free-standing or on the sides of a free-standing range.  The Sink is shown as UM which means Undermount.  Topmount sinks are shown as TM. 

3.  Cooktops are noted, as well as separate downdrafts with the abbreviation CT.  Please note if you have a slide-in range vs. a free-standing stove.  Slide-in Ranges have a small rail of countertop behind them.

4.  If you have a raised bar, you can used dashed line to indicate it's location.  Note what height you want the splash between the two levels.  Most popular is 6", but some are 4 or 4.5".

5.  Corners can have a radius up to 1" at no charge.  If your radius exceeds 1" please mark R on the corner edge to indicate and also show the inches of radius desired.  Custom radiuses over 6" incur additional charges.

6.  Please indicate if you are requesting a bid for removal and final hookups to be included in your price. 

7.  Indicate if you would like to purchase one of our sinks.  Models are 50/50 or 60/40.  Also denote number of faucet holes needed, if known

8.  Your name, address and jobsite address are needed for a written quote.  We can email the quote to you if you also provide your email address.